THESE ARE THE BASICS THAT SHOULD GET YOU GOING.

Start the GSP program

A Box called 'OCD FLASH Registration' pops up. Enter 1 for the Registration Code and click on OK.

From the FILE menu choose OPEN and select the file that matches the flash chip on your simba (Simba AMD Flash.ocd, Simba SHARP Flash.ocd or Simba TOSHIBA Flash.ocd - the toshiba file is definitely ok as I use it myself, the other two should be okay).

TO DUMP THE CONTENTS OF SIMBA FLASH TO FILE (BOOT AND APPLI):
Click on RESET TARGET, a box should pop up saying TARGET RESET ASSERTED click on OK in that box.
Click on UPLOAD FLASH, after a delay of a few seconds a box will open called 'Upload Flash to .s19 File'. Enter a file name next to UPLOAD FLASH TO: then click on UPLOAD.
It will take around fifteen minutes to complete, when it has click on CLOSE to return to the main options.

TO REPROGRAM THE SIMBA FLASH FROM FILE (BOOT OR BOOT & APPLI):
Click on RESET TARGET, a box should pop up saying TARGET RESET ASSERTED click on OK in that box.
Click on PROGRAM, after a delay of a few secons a box will open called 'Program Flash'.
Enter a filename next to READ PROGRAM FROM: (Use the BROWSE button if you need to). Make sure the check box is ticked next to ERASE TARGET FLASH SECTOR(S) BEFORE PROGRAMMING.
Click on PROGRAM. You should see it erase the necessary sectors and then proceed to program them. The boot on it's own takes about five minutes, the boot & appli will take around fifteen minutes to complete.
When it has finished click on CLOSE to return to the main options.
If you flashed ONLY THE BOOT then you may have to reflash the appli using the LOADER.EXE program through the RJ45 port.

